Phone: 0086-755-29607200 Email: SALES@CKGLED.COM

Detail

Home / News / Detail

..

Little common sense about the life of LED display screen, how much do you know?

2019-09-05 09:31:01

The theoretical life of LED display is up to 100,000 hours. In practical applications, due to the influence of the external environment, especially in products that have been used for more than 5 years, small defects occasionally occur. In order to make the LED display closer to the theoretical life, practitioners must understand the small common sense of LED cleaning and LED over-current protection, and can use it comprehensively.

 

 

1, LED pin forming method

1) It is necessary to bend the bracket 2 mm from the gel.

2) Bracket forming must be done with a clamp or by a professional.

3) Bracket forming must be completed before welding.

4) The bracket is formed to ensure that the pins and spacing are consistent with the board.

 

2, LED needs to pay attention to the process of bending and cutting the foot

1) Due to the design, the foot and the cutting foot are required. When the LED is bent and cut, the position of the bending foot and the cutting foot is more than 3 mm from the bottom surface of the colloid, and the bending foot should be performed before welding.

2) When using the LED to insert the lamp, the PCB board hole spacing should correspond to the LED pin spacing.

When the foot is cut, the high-voltage static electricity is generated due to the vibration of the cutting machine. Therefore, the machine should be grounded reliably, and the anti-static work should be done (the ion fan can be blown to eliminate static electricity).

 

3, LED cleaning

Special care must be taken when cleaning the gel with chemicals, as some chemicals damage the surface of the gel and cause fading such as trichloroethylene, acetone, and the like. It can be wiped and dipped with ethanol for less than 3 minutes at room temperature.

 

4, LED overcurrent protection

Overcurrent protection can be used to stabilize the LED series protection resistor

The resistance value is calculated as: R=(VCC-VF)/IF

VCC is the power supply voltage, VF is the LED drive voltage, and IF is the forward current.

Welcome to contact us http://www.ckgled.net/

5, LED welding conditions

1) Soldering iron soldering: The soldering iron (up to 30W) tip temperature does not exceed 300 °C, the soldering time does not exceed 3 seconds, and the soldering position is at least 2 mm from the colloid.

2) Wave soldering: The maximum temperature of dip soldering is 260 ° C, the dip soldering time is less than 5 seconds, and the dip soldering position is at least 2 mm from the colloid.

 

CKGLED strictly implements the ISO9001 quality certification system in the manufacturing process, which effectively guarantees the product quality. In addition, a large number of high-

Inquiry

Meeting customer needs is our only goal and motivation

We offer the best quality, the best service and the fastest response, just to reassure the customers